Encyclopedia of Experiments
Biological Techniques
Un abonnement à JoVE est nécessaire pour voir ce contenu.  Connectez-vous ou commencez votre essai gratuit.
Encyclopedia of Experiments Biological Techniques
Bead Sprouting Assay for Early-Stage Angiogenesis Assessment: An In Vitro Bead-Based Model to Study Endothelial Sprouting in the Presence of Pericytes

Bead Sprouting Assay for Early-Stage Angiogenesis Assessment: An In Vitro Bead-Based Model to Study Endothelial Sprouting in the Presence of Pericytes

Transcription

Examine the dishes of microcarrier-coated beads under the microscope at 20 times magnification to confirm that all of the beads have been sufficiently coated by the endothelial cells.

Transfer the plates to a laminar flow hood, and use a P1000 pipette to vigorously aspirate and dispense the coated-beads solutions to detach the cells from the plate bottoms, and transfer the supernatants into individual tubes.

Allow the beads to settle to the bottoms of the tubes for three minutes. Then, use the P1000 pipette to remove as much of the supernatants as possible without disturbing the bead clusters. Resuspend the beads in one milliliter of complete medium per tube, and allow the beads to settle for 30 to 60 seconds. Use the P1000 pipette to aspirate the supernatant again, and wash the free-floating endothelial cells from the bead suspension with fresh complete medium, two more times, as just demonstrated.

After the third wash, resuspend the beads in 2.5 milliliters of fibrinogen solution. Add 13 microliters of thrombin solution per well, in a 24-well glass bottom plate. Then, add 0.5 milliliters of the bead/fibrinogen solution to each well, taking care to carefully pipette the beads directly into the thrombin, and slowly pipette up and down two to three times to thoroughly mix the solutions.

When all of the wells have been seeded, allow the thrombin-fibrinogen solution to pre-clot in the laminar flow hood for 30 minutes at room temperature. At the end of the incubation, carefully transfer the plate to a 37-degree Celsius incubator for an additional 1.5 to 2 hours.

When the gel has fully solidified, resuspend normal human lung fibroblasts at 2 x 104 cells per milliliter concentration in complete medium, and add one milliliter of fibroblasts to each well. Then, return the plate to the cell culture incubator.

Vidéos Connexes

Read Article