Journal
/
Ingénierie
/
Calibration Procedures for Orthogonal Superposition Rheology
Journal JoVE
Ingénierie
Un abonnement à JoVE est nécessaire pour voir ce contenu.  Connectez-vous ou commencez votre essai gratuit.
Journal JoVE Ingénierie
Calibration Procedures for Orthogonal Superposition Rheology

Calibration Procedures for Orthogonal Superposition Rheology

DOI:
10.3791/61965-v

•

08:43 min

•

November 18, 2020

•

,
1Material Measurement Laboratory,National Institute of Standards and Technology, 2Department of Chemical Engineering,Texas Tech University

Chapitres

  • 00:04Introduction
  • 00:57Rheometer Setup
  • 02:17Test Material Loading
  • 03:38Viscosity Calibration Measurement and Verification
  • 06:02Results: Representative Steady-Shear Sweep and Orthogonal Frequency Sweep Testing and Analysis
  • 07:56Conclusion

Summary

Traduction automatique

Traduction automatique

We present a detailed calibration protocol for a commercial orthogonal superposition rheology technique using Newtonian fluids including end-effect correction factor determination methods and recommendations for best practices to reduce experimental error.

Tags

Keywords: Orthogonal Superposition RheologyCalibration ProceduresMeasurement ErrorEnd Effect FactorsTemperature MeasurementEnvironmental ControlGeometry AssemblyTransducer ZeroingSample Loading

Article

Embed

AJOUTER À LA PLAYLIST

Usage Statistics

Vidéos Connexes

check_url/fr/61965?article_type=v

Bringing the Visible Universe into Focus with Robo-AO
check_url/fr/61965?article_type=v

Concurrent Quantitative Conductivity and Mechanical Properties Measurements of Organic Photovoltaic Materials using AFM
check_url/fr/61965?article_type=v

Detection and Recovery of Palladium, Gold and Cobalt Metals from the Urban Mine Using Novel Sensors/Adsorbents Designated with Nanoscale Wagon-wheel-shaped Pores
check_url/fr/61965?article_type=v

Dielectric RheoSANS — Simultaneous Interrogation of Impedance, Rheology and Small Angle Neutron Scattering of Complex Fluids
check_url/fr/61965?article_type=v

Resonance Fluorescence of an InGaAs Quantum Dot in a Planar Cavity Using Orthogonal Excitation and Detection
check_url/fr/61965?article_type=v

Fabrication Procedures and Birefringence Measurements for Designing Magnetically Responsive Lanthanide Ion Chelating Phospholipid Assemblies
check_url/fr/61965?article_type=v

Atmospheric Pressure Fabrication of Large-Sized Single-Layer Rectangular SnSe Flakes
check_url/fr/61965?article_type=v

Hybrid Printing for the Fabrication of Smart Sensors
check_url/fr/61965?article_type=v

Cutting Procedures, Tensile Testing, and Ageing of Flexible Unidirectional Composite Laminates
check_url/fr/61965?article_type=v

Procedure for the Transfer of Polymer Films Onto Porous Substrates with Minimized Defects

Read Article