Rivista
/
Ingegneria
/
Micromechanical Tension Testing of Additively Manufactured 17-4 PH Stainless Steel Specimens
JoVE Journal
Ingegneria
This content is Free Access.
JoVE Journal Ingegneria
Micromechanical Tension Testing of Additively Manufactured 17-4 PH Stainless Steel Specimens

Micromechanical Tension Testing of Additively Manufactured 17-4 PH Stainless Steel Specimens

DOI:
10.3791/62433-v

•

05:38 min

•

April 07, 2021

•

, , , , ,
1Department of Civil Engineering,University of Arkansas, 2Department of Mechanical Engineering,University of Arkansas

Capitoli

  • 00:04Introduction
  • 01:02Sample Preparation for Photolithography
  • 01:41Performing the Photo-Resist Patterning
  • 02:40Wet-etching and FIB Milling
  • 03:34Micro-Tensile Test
  • 04:12Results: Analysis of the Prepared Steel Surface
  • 04:56Conclusion

Summary

Traduzione automatica

Traduzione automatica

Presented here is a procedure for measuring fundamental material properties through micromechanical tension testing. Described are the methods for micro-tensile specimen fabrication (allowing rapid micro-specimen fabrication from bulk material volumes by combining photolithography, chemical etching, and focused ion beam milling), indenter tip modification, and micromechanical tension testing (including an example).

Tags

Micromechanical Tension TestingAdditively Manufactured17-4 PH Stainless SteelPhotolithographyMicro Tensile GripWet EtchingSample AlignmentPolishingDicing SawSpin CoderPhoto ResistPhoto MaskPropylene Glycol Monomethyl Ether AcetateEtchingMicro Electromechanical SystemsMEMS

Article

Embed

AGGIUNGI ALLA PLAYLIST

Usage Statistics

Video correlati

check_url/it/62433?article_type=v

Construction and Testing of Coin Cells of Lithium Ion Batteries
check_url/it/62433?article_type=v

Fabrication of VB2/Air Cells for Electrochemical Testing
check_url/it/62433?article_type=v

Fabrication and Testing of Microfluidic Optomechanical Oscillators
check_url/it/62433?article_type=v

Mechanical Expansion of Steel Tubing as a Solution to Leaky Wellbores
check_url/it/62433?article_type=v

The Evolution of Silica Nanoparticle-polyester Coatings on Surfaces Exposed to Sunlight
check_url/it/62433?article_type=v

Subsurface Defect Localization by Structured Heating Using Laser Projected Photothermal Thermography
check_url/it/62433?article_type=v

A Novel Method for In Situ Electromechanical Characterization of Nanoscale Specimens
check_url/it/62433?article_type=v

Preparation and High-temperature Anti-adhesion Behavior of a Slippery Surface on Stainless Steel
check_url/it/62433?article_type=v

Preparation of Aligned Steel Fiber Reinforced Cementitious Composite and Its Flexural Behavior
check_url/it/62433?article_type=v

Ultrasonic Fatigue Testing in the Tension-Compression Mode

Read Article