Journal
/
Engenharia
/
Calibration Procedures for Orthogonal Superposition Rheology
JoVE Journal
Engenharia
É necessária uma assinatura da JoVE para visualizar este conteúdo.  Faça login ou comece sua avaliação gratuita.
JoVE Journal Engenharia
Calibration Procedures for Orthogonal Superposition Rheology

Calibration Procedures for Orthogonal Superposition Rheology

DOI:
10.3791/61965-v

•

08:43 min

•

November 18, 2020

•

,
1Material Measurement Laboratory,National Institute of Standards and Technology, 2Department of Chemical Engineering,Texas Tech University

Capítulos

  • 00:04Introduction
  • 00:57Rheometer Setup
  • 02:17Test Material Loading
  • 03:38Viscosity Calibration Measurement and Verification
  • 06:02Results: Representative Steady-Shear Sweep and Orthogonal Frequency Sweep Testing and Analysis
  • 07:56Conclusion

Summary

Tadução automática

Tadução automática

We present a detailed calibration protocol for a commercial orthogonal superposition rheology technique using Newtonian fluids including end-effect correction factor determination methods and recommendations for best practices to reduce experimental error.

Tags

Keywords: Orthogonal Superposition RheologyCalibration ProceduresMeasurement ErrorEnd Effect FactorsTemperature MeasurementEnvironmental ControlGeometry AssemblyTransducer ZeroingSample Loading

Article

Embed

ADICIONAR À PLAYLIST

Usage Statistics

Vídeos Relacionados

check_url/pt/61965?article_type=v

Bringing the Visible Universe into Focus with Robo-AO
check_url/pt/61965?article_type=v

Concurrent Quantitative Conductivity and Mechanical Properties Measurements of Organic Photovoltaic Materials using AFM
check_url/pt/61965?article_type=v

Detection and Recovery of Palladium, Gold and Cobalt Metals from the Urban Mine Using Novel Sensors/Adsorbents Designated with Nanoscale Wagon-wheel-shaped Pores
check_url/pt/61965?article_type=v

Dielectric RheoSANS — Simultaneous Interrogation of Impedance, Rheology and Small Angle Neutron Scattering of Complex Fluids
check_url/pt/61965?article_type=v

Resonance Fluorescence of an InGaAs Quantum Dot in a Planar Cavity Using Orthogonal Excitation and Detection
check_url/pt/61965?article_type=v

Fabrication Procedures and Birefringence Measurements for Designing Magnetically Responsive Lanthanide Ion Chelating Phospholipid Assemblies
check_url/pt/61965?article_type=v

Atmospheric Pressure Fabrication of Large-Sized Single-Layer Rectangular SnSe Flakes
check_url/pt/61965?article_type=v

Hybrid Printing for the Fabrication of Smart Sensors
check_url/pt/61965?article_type=v

Cutting Procedures, Tensile Testing, and Ageing of Flexible Unidirectional Composite Laminates
check_url/pt/61965?article_type=v

Procedure for the Transfer of Polymer Films Onto Porous Substrates with Minimized Defects

Read Article