Journal
/
Engenharia
/
Twin-Screw Extrusion Process to Produce Renewable Fiberboards
JoVE Journal
Engenharia
É necessária uma assinatura da JoVE para visualizar este conteúdo.  Faça login ou comece sua avaliação gratuita.
JoVE Journal Engenharia
Twin-Screw Extrusion Process to Produce Renewable Fiberboards

Twin-Screw Extrusion Process to Produce Renewable Fiberboards

DOI:
10.3791/62072-v

•

07:21 min

•

January 27, 2021

•

, , , , ,
1Laboratoire de Chimie Agro-industrielle (LCA),Université de Toulouse, INRAE, INPT, 2Balochistan University of Information Technology, Engineering and Management Sciences, 3Laboratoire Génie de Production (LGP),Université de Toulouse, INPT

Capítulos

  • 00:04Introduction
  • 01:14Twin-Screw Extruder Preparation
  • 02:34Twin-Screw Extrusion Treatment
  • 04:41Extrudate Drying and Fiberboard Molding
  • 05:18Results: Representative Renewable Fiberboard Production and Analysis
  • 06:52Conclusion

Summary

Tadução automática

Tadução automática

A versatile twin-screw extrusion process to provide an efficient thermo-mechano-chemical pretreatment on lignocellulosic biomass was developed, which leads to an increased average fiber aspect ratio. A natural binder can also be added continuously after fiber refining, leading to bio-based fiberboards with improved mechanical properties after hot pressing of the obtained extruded material.

Tags

Keywords: Twin-screw ExtrusionRenewable FiberboardsLignocellulosic BiomassesPretreatmentThermo-mechanical PulpsNatural BinderTemperature Moisture ContentFiber DefibrationScrew ElementsBarrelTemperature ControlWater Flow Rate

Article

Embed

ADICIONAR À PLAYLIST

Usage Statistics

Vídeos Relacionados

check_url/pt/62072?article_type=v

How to Ignite an Atmospheric Pressure Microwave Plasma Torch without Any Additional Igniters
check_url/pt/62072?article_type=v

A Cost-effective and Reliable Method to Predict Mechanical Stress in Single-use and Standard Pumps
check_url/pt/62072?article_type=v

Integration of Light Trapping Silver Nanostructures in Hydrogenated Microcrystalline Silicon Solar Cells by Transfer Printing
check_url/pt/62072?article_type=v

Development of an Experimental Setup for the Measurement of the Coefficient of Restitution under Vacuum Conditions
check_url/pt/62072?article_type=v

Adsorption Device Based on a Langatate Crystal Microbalance for High Temperature High Pressure Gas Adsorption in Zeolite H-ZSM-5
check_url/pt/62072?article_type=v

Challenges in Rheological Characterization of Highly Concentrated Suspensions — A Case Study for Screen-printing Silver Pastes
check_url/pt/62072?article_type=v

Fabrication Procedures and Birefringence Measurements for Designing Magnetically Responsive Lanthanide Ion Chelating Phospholipid Assemblies
check_url/pt/62072?article_type=v

Predicting Catalyst Extrudate Breakage Based on the Modulus of Rupture
check_url/pt/62072?article_type=v

Combining Microfluidics and Microrheology to Determine Rheological Properties of Soft Matter during Repeated Phase Transitions
check_url/pt/62072?article_type=v

O-cresol Concentration Online Measurement Based On Near Infrared Spectroscopy Via Partial Least Square Regression

Read Article